MCS DMAG / HELIX to Tippmann 98 Magazine side

here is a side design. with some space left for in case you use a response trigger upgrade

bitchute movie link: https://www.bitchute.com/video/NZlRmetBmjad/
https://www.youtube.com/watch?v=tkegaAAC0ws
link to the Installation video of the Dmag magfed adapter

DMAG Bren LMG
https://www.thingiverse.com/thing:3937441
DMAG FG 42, P90 (Right)
https://www.thingiverse.com/thing:3937500
DMAG P90 (centered)
https://www.thingiverse.com/thing:3937473
DMAG FG 42, P90 (Right)
https://www.thingiverse.com/thing:3937457
DMAG Tall High
https://www.thingiverse.com/thing:3937511
DMAG Tall Low
https://www.thingiverse.com/thing:3937523
DMAG TIP98 normal
https://www.thingiverse.com/thing:4115746
DMAG TIP98 side
https://www.thingiverse.com/thing:4188333
DMAG TIP98 down
https://www.thingiverse.com/thing:4190624
DMAG cyclone side
https://www.thingiverse.com/thing:4227717
DMAG cyclone up
https://www.thingiverse.com/thing:4227722
DMAG cyclone down
https://www.thingiverse.com/thing:4227712
TMC Bren LMG
https://www.thingiverse.com/thing:3790969
TMC FG 42, P90 (Left)
https://www.thingiverse.com/thing:3919897
TMC FG 42, P90 (Right)
https://www.thingiverse.com/thing:3918514
TMC P90 (centered)
https://www.thingiverse.com/thing:3925118
TMC Tall high
https://www.thingiverse.com/thing:3925141
TMC Tall Low
https://www.thingiverse.com/thing:3925181
TMC TIP98 normal
https://www.thingiverse.com/thing:4112853
TMC TIP98 SIDE
https://www.thingiverse.com/thing:4188772
TMC TIP98 down
https://www.thingiverse.com/thing:4188787
TMC cyclone SIDE
https://www.thingiverse.com/thing:4224827
TMC cyclone down
https://www.thingiverse.com/thing:4226365
TMC cyclone up
https://www.thingiverse.com/thing:4226396

Print Settings

Supports:

Yes

Infill:

40%

Post-Printing

it can be a smart thing to melt in a iron or copper wire in the part shown in the picture. or print that section with a higher infill. at first was I surprised that it looked that is was not needed. but I had a failure on my second print so. keep that weak spot in mind.

for use of the 2 pins, just use 2x m3 bolts with a length of 12mm.
and of course 1 spring and 2 pins are needed to make the mag catch work.