Whirlpool Dryer Handle - Tough

I designed this handle as an upgrade for our whirlpool dryer after the original broke.  It has been in service since February of 2019 without any issue.  I used four 10-24 x ¾ screws to install it, but you could use m5 x 15mm if needed.  I designed it so you could put all together with the screws holding the nuts and as tightend the nuts would spin and catch in the grooves and tighten down.  Installed without any issues for me.  I only used a screwdriver so I wouldn't overtighten the screws.

Should be printed out of ABS, ASA or PETG for best results.  PLA would probably not handle the heat!