Skateboard Bearing Holder

Skateboard Bearing Holder
A convenient container for holding numerous 608ZZ (22mm x 7mm) bearings, made for skateboards, used widely.

This is a remix of Rollerblades 22mm bearing holder with lid by Max P.

I liked his look and the overall size of his model.
However, for me it needed a few changes: 
Most importantly, the lid didn't match the container. 
The container itself had internal posts meant to separate the bearing columns. For me, the separating posts made it more difficult to use.

This remake was created from scratch using OpenSCAD.

The primary differences between this model and Max P.'s are:

• The lid fits well
• There are no internal separating posts
• There's a little more room between bearing stacks.

Included are:

• two sizes of the bearing container
• a lid which fits both sizes of container
• a second lid with embedded text (Bambu only)

The two differently-sized containers hold:
* 35 bearings - 5 per post
* 70 bearings - 10 per post

Printing this model is quite forgiving. Prints fine with PLA or PETG, likely others.
I printed it using:  

• PLA+
• 3 walls
• 15% Gyroid Infill
• No supports, raft, or brim

NOTE: the included 3mf of the lid with a label can only be used by Bambu Slicer. 

Added simple lid
Added lid with simple label
Removed internal separating posts
Added a bit more room between bearing stacks
Includes two sizes: one holding 35 bearings and one holding 70.