Heltec V3 and RAK Case

Designed for both Heltec V3 and RAK boards in mind. When attaching the Heltec V3 board to the carrier board remove screws on heltec screen and put board on carrier then replace screws with M2.0*6 screws and attach to board to carrier. Has spot to mount GPS GT-U7 module and BME280 sensor. Also has spot to mount 18650 battery holder or you can mount a flat battery. I utilize 18650 batteries because they are safer with moisture. 

Parts:

1. M3 H4 threaded inserts
2. M2.4 H4 threaded inserts
3. M2.5 Screws
4. M3.0 Screws
5. 2MM plexiglass
6. GPS external antenna
7. LoRa Antenna for whatever frequency you are using
8. GT-U7 GPS Module
9. BME280 sensor
10. Micro Mini Slide Switch

Print settings-

PETG or PLA, you can see the settings I have used in the photos. 

Printer Used- Ender 3 Pro, Sonic Pad, Sprite Pro Extruder

Please respect the creative commons license I have chosen-

Meshtastic Case V4 © 2024 by Bay Electronics&Design LLC is licensed under Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International 

If anyone is interested in licensing this design or would like to buy the case please reach out to me at www.bayelectronics.org