Mr. T Ground Stake

The Mr. T Ground Stake was originally designed to keep one of our garden decorations in place, where strong winds caused other stakes to loosen up over time.

Once installed, the Mr. T Ground Stake can be difficult to remove (Mr T:  "don't mess with me fool"); since its' built-in holes fill with dirt helping to kind of ‘cement’ it in place.

It's great for keeping items staked down, which would be prone to moving around under strong winds.

Since it's designed for relatively soft garden soil, I don't recommend that you hammer it into the ground, but instead either push it in by hand or foot (just be careful not to trip or fall while doing so).

Recommended printing is with 5 or more walls and about 20% infill.

2024-06-23:  Updated the model to make it less prone to layer shifts caused by nozzle collisions with overhangs during printing.