Was asked to come up with a design that would allow up to four bottles to drip dry without touching the mouth to the base.
In the first version of this design went from a stand on bottle mouth holder to a caged bottle holder. In both cases not all requirements were met, and the bottle could move about so much as to fall over.
On to version 2: Combined the two together to hold the bottles up off the base and still steady the bottle mouth to reduce any wobble. This design worked out well.
In testing went from a single bottle holder on to a double and finally a quad. Each is available here.
Print-In-Place (PIP) model meaning that no supports are required to print this design.
The author marked this model as their own original creation.
