Smaller Drill Nub
Made the pin smaller because it was impossible to put it on without it breaking
1
33
0
117
updated
May 13, 2024
Summary
PDFMade the pin smaller because it was impossible to put it on without it breaking
Model origin
The author remixed this model.
Differences of the remix compared to the original
Made the pin smaller because it was impossible to put it on without it breaking. Yes I did print this but I don't want to take it out again because i already printed WAY too many of these.
Print Settings
-4 perimeters
-0.15 layer height
Rest shouldn't matter but if you still have issues try to increase the print temp by a few degrees.