RFID Hexagon Holder
This model holds a rfid card that we use at my work. The size of the card is approx 53.8 x 85.7 x 1.7 but I rounded up.
1
16
0
111
updated
May 12, 2024
Description
PDFI printed this on its long flat side with no supports on my Mini+. PLA is fine as when the card is in it the card will prevent breakage. I also added a small hole in the bottom to poke something through for easier removal as my tolerances are snug.
Model origin
The author remixed this model.
Differences of the remix compared to the original
So I used very similar spacing to the original model by using calipers. The original design was too big for our cards at work so I took the original model and started from scratch in fusion to create one that fit my card.
