FGC-6 S AF H: TEC9 M and L MKII MKIISD outer barrel and suppressor set

as part of the big V24 update. the 14mmccw barrels have been made a bit stronger

-

14mm CWW barrel tips have been added ---

this is a 300mm long barrel replica made for the TEC9 L shroud. that works for the MKII version of the FGC6.

and the way in install the two piece outer barrel is to install the 2 lower bolts first in your shroud. then slide the outer barrel in your shroud. and install the 2 m3 bolts at the top 2 holes of the shroud

-

these are the 2023 versions of the Outer barels for the FGC6 MKI/MKII (s, FA, H) platform. this barrel will have a tighter Inner diameter size at the tip of the barrel. this will act like a inner barrel stabiliser so in other words it prevent it form moving around.

but before you select and print a outer barrel. make sure that your FGC6 is working correctly. and take a close look at the barrel adapter that you use.

the file naming works as fallows: 
227 slim barrel 00mm 9 18mmID
(227 slim = shroud model) (barrel = what type of barrel) (00mm = inner barrel hight) (9 18mmID = inner barrel OD size)

-

this outer barrel is made to work with the fallowing models:
FGC9-MKIIsd TEC9 L SHROUD set
https://www.printables.com/model/88697-fgc9-mkiisd-tec9-l-shroud-set

-
the video about it can be found here.
https://odysee.com/@UntangleWORKS:a/FGC6FA-outerbarrel:f
https://youtu.be/0dA8RhMdQiI

-

materials needed:
shroud
4x M3 washer
4x bolt m3 35mm or 40mm long

2 piece barrel
2x m3 18mm long

suppressor 
2x bolt m2,5 18mm or 20mm long

-

print settings:
0.2 layer hight should be fine.
you can use the 8 layer walls and a 40% infill.
but personally I moved a bit over to solid prints just to give it more strength in case things go wrong on the field…