Spacious ESP32 enclosure, magnets on bottom, DHT11, 4x-Dupont Pin-out, snap together, no screws

ESP32 devboard enclosure, big enough to keep the pins attached and use Dupont connectors to the ESP.

The enclosure is designed for an ESP-32 Dev Kit C V4 like this one, but should also work with other boards of the same size, as the board is held from the sides.

There is a opening on the side to fit an DHT11 temperature / moisture sensor.
On the other side is an opening for a 4-pin dupont connector. I used a drip of hot glue to fix an angled pin header for taking the Dupont-connector from outside.

In the bottom you may optionally place up to two 12mmx3mm round magnets, allowing the enclosure to be placed to any metal surface like a switch cabinet.

I used it for my Hitchi IR reader on a cable, to place the ESP32 outside of my switching cabinet for better WiFi range.