5A Cable Splitter

A fairly compact 5A Cable Splitter for cables with a 6mm diameter or less. 5A Connector Blocks and screws needed. Splits 1 cable out to 3.

5A Connector Blocks I used for these can be found here but most 5A blocks should be standard size and fit well in the holders. 

All screws for the lid, securing the cable holder to a surface/wall and cable holders are the same size. I used 4 x 20mm Torx Countersunk Wood Screws. 

Works well for light splitters etc, especially for Edison bulbs or similar. 

Printed mine in PETG but anything should be fine with the exception of the cable holders where PLA might be too brittle. 

Enjoy 😄