Adapter for Bicycle Bell Children's Tricycle

Grandkid needed a new tricycle bell. Tube diameter 16mm, bell inner 22mm. 

1. Step: Measure OD Ø16 and ID Ø22mm.
2. Step: Start TinkerCad, draw a Ø22mmx18 cylinder, another two Ø24x3mm cylinders, arrange the two at to and at end, center align all, group and cut a Ø16mm hole. Make a diagonal cut through one side for assembly reasons, make a groove cut on opposite side for flexibility when opening the diagonal cut section.
3. Step: Print in TPU.
4. Step: Mount the adapter on the steering rod.
5. Step: Mount the (new) bell over the adapter and tighten thoroughly.

Printed with darkblue TPU on my MK3s+ with bypassing my MMU2s.

Note: SAFETY FIRST! IT IS A GOOD REASON TO EQUIP A TRICYCLE WITH A BELL!

Grandkid happy - Grandpa happy!

Explore my other Printables: https://www.printables.com/de/@Tritschi