MMU3-Frame-Holder in various angles

I was unhappy in the way the original holder forces the tubes downwards. Because of that it isn´t possible to print large parts without touching the PTFE-tubes in the back.  Other than that the available remixes I´ve found didn´t have the maintenance-holder on it.
 

Therefore I´ve remix the original model to allow the MMU3 to hang in different angles and to use the maintanance holder as well. 
 

Note that there is a left and a right Version of the holder (the screws are on the inside). 

It should be printed like the original-modell:

• Filament: PETG 
• 20% Grid infill
• Print settings: 0.20mm QUALITY

The pictures show the 20°-Version of my remix

ATTENTION:

It can be hard to screw in the prusa frontplate with the new angles. I have two solution:

1. Don‘t tighten the screws that hold the MMU3 all the way in (you could also connect the two holders with the frontplate first) and then tighten the screws that hold the MMU fully.
2. Sanding the frontplate a bit, where it pushes against the MMU.