Cartridge screw cap with sealing ring

Cartridge screw cap with sealing ring / Kartuschen-Schraubverschluss mit Dichtring
16
79
1
267
updated May 10, 2024

Description

PDF

There are a number of cartridge lids available here and I have tried several. But something was always wrong, either the threaded hole wasn't deep enough, there was too much play in the thread or the sealing ring used was nowhere to be found.

Since I had sealing rings in the house, I took up the good idea and made my own design around the existing rings. These are rings measuring 19 x 3.5 (https://www.ebay.de/itm/402586654275?var=672878685756).
 

The contact surface is adapted to the bevel at the end of the cartridge so that the seal rests well. The sealing ring snaps into place, so it does not need to be glued.

Print with any filament without support with the opening facing upwards due to the slightly sloping bottom.

---------------------------------------------------------------------

Es gibt hier eine Reihe von Kartuschendeckeln und ich habe mehrere ausprobiert. Aber irgendetwas stimmte immer nicht, entweder war die Gewindebohrung nicht tief genug, zu viel Spiel im Gewinde  oder der verwendete Dichtring war nirgends zu bekommen. 

Da ich Dichtringe im Hause hatte, habe ich daher die gute Idee aufgegriffen und um die vorhandenen Ringe ein eigenes Design gemacht. Es handelt sich um Ringe in der Größe 19 x 3,5 (https://www.ebay.de/itm/402586654275?var=672878685756).

Die Auflagefläche ist der Schrägung am Kartuschenende angepasst, so dass die Dichtung gut aufliegt. Der Dichtring rastet ein, muss also nicht geklebt werden.

Drucken mit beliebigem Filament ohne Support mit der Öffnung nach oben, wegen der leicht schrägen Unterseite. 
 

Tags



Model origin

The author marked this model as their own original creation.

License