Simple monolithic non adjustable mounts for Valve's Lighthouse 2.0 Base stations, (not for LH1.0, not tested with HTC Vive LH2.0)
ideal for permanently mounting you Base stations, can be used as Wall or ceiling mounts, same hole pattern as with the standard mounts but more compact and less prone to vibrations
Each mount uses 2 3D printed ¼" 20tpi screw for maximum stability and durability
17 variations:
-9 tilt angles in 5° increment from 25° to 65° (ideal for ceiling mounting)
-5 panning angles: -45° -15° 0° +15° +45° (+/- 15/45 only available for 40° & 55° tilt angles for ideal wall mounting)
this should be sufficient to cover for 99% of use cases.
STLs are already in their ideal printing orientation, can be printed with minimal supports with bridging enabled, PLA or PET-G
for mounting to walls or ceilings, it's a drop-in replacement to standard base stations mounts so no need to drill new holes if it was already mounted well vertical, the screw holes are optimized for countersunk wood screws but will also work fine for other screw head shapes
part naming meaning:
(designation)-(tilt down angle)-(panning angle Left/Right)
The author marked this model as their own original creation.