(un)original Prusa Drybox stand for Original Prusa Enclosure

I wanted the same kind of stand that the RepBox one for my (un)original Prusa Drybox on the top of my Original Prusa Enclosure.

To stay removable, I didn't fixed the drybox but I used its feet as connexion to the stand.

The stand has 4 feet fixed on the Prusa Enclosure with :

• 2x m3 nuts per foot
• 1x m3s square nut for each rear foot
• 1x 6mm, 1x 8mm, 1x 10mm m3 screws for each rear foot
• 2x 8mm m3 screws for each front foot

In total :

• 8x m3 nuts
• 2x m3s square nuts
• 2x 6mm screws
• 8x 8mm screws
• 2x10 mm screws

Printed in PTEG, 3 perimeters, 20% infill

As the feet are symmetrical, I put only the left feet for the .STEP version.