(v1) Project Babble snap-in case for Meta Quest 3

Check the new v2 here

v2 features include holding a fully wireless build with a battery, usb-c charging board, power switch and more!

Project Babble is an open source mouth tracking project designed to work with any VR headset.

This is a case I designed to hold an ESP32-CAM, camera, two or more LEDs, and voltage regulator circuit. It can host a complete Project Babble setup in a tiny footprint. It's meant to clip to the front of the Quest 3. Insert it into the faceplate crevice and then hook to the nose bridge (see pictures). 

Depending on printer or filament used the lid might not stay in place unless you use some glue. I'm really bad at 3D modeling so you are encouraged to remix and improve on it as long as you credit me. 

Printing recommendation:

Lower part: Can be printed in PLA, print standing as is, or sideways.

Lid: A more heat-resistant material such as PETG is advised, lay flat.

License: CC BY-NC