I was looking for a way to better organize my power tools that was near where I keep the battery chargers. After looking at a few ideas others had come up with I opted to make my own hanging design that hangs from the lip of the lid of my open tool chest where I keep the chargers.
This particular design has the slot for the tool offset a bit to allow for the clip on the side to fit between the vertical hangers.
Print two of the hangers and just snap them on to the tool base.
Note:
I imagine different tool chests will have different lids and handles. Inspect yours before you print this only to find out it won't work for you.
Note about batteries:
I intentionally designed this hanger so the tool with a small battery will fit. The larger batteries are a fair bit heavier and I figured I shouldn't get too much weight hanging from 3d printed plastic parts. While I'm sure it WOULD hold, for at least a little while, I was trying to prevent myself from breaking something and headache that may result.
The author marked this model as their own original creation.