Ladder for G1 Micromaster Combiner Metro Squad Roadburner

Occasionally I'll find a second-hand Micromaster toy figure from the 90's, but their small parts are almost always missing. Especially this fire engine is not much of a fire engine without its ladder, so I recreated the ladder from some photos. It's a little different from the original, which could fold in two, but that also makes this one less likely to break. It even adds some support in robot mode.

Recommended PLA print settings:
0.1mm layer height
single wall
30% infill
print speed 20mm/s
outer wall speed 5mm/s
support line distance 1.55mm + support infill line direction [90] (lengthwise)
combing on
retraction on