Spool holder for 150mm bearing

I wanted a way to print directly from my cheap food dehydrator. Using a 150x150mm lazy susan bearing meant for furniture, I made this spool holder. It installs using printed studs, and the bearing is zip tied to the dehydrator base. The studs should be a very tight fit, if they come loose during print it could cause a filament jam.

My dehydrator goes up to 70 degrees, printed in ABS to resist the heat. PETG should also work.

I used this bearing https://www.linaa.dk/shop/drejebeslag-150x150-firkantet-1596p.html

The larger holes are spaced 132mm apart, and the holes are 6.7mm

Design is very much inspired by https://www.thingiverse.com/thing:4078397

Also seen in my image is:

• PTFE connector https://www.printables.com/model/560942
• Dehydrator walls https://www.printables.com/model/58726

Now I just need a nice way to position my filament dehydrator next to the printer without needing to move the AMS unit.