Wacom Cintiq Pro 13 / Ipad / Tablet desktop stand

Patreon - https://patreon.com/CosmicNimbusPrinting 
Cults3D - https://cults3d.com/en/users/CosmicNimbus

Hi !

I looked around at different stands for ipads to remix for my Wacom Pro 13, but wanted something a bit more sturdy. So I came up with this bad boy

After printing the stand at 5 degrees lean back, it turned out to be not quite enough for the viewing angle and for the wacom's centre of gravity. So I made some chocks to add to my print that makes the stand 10 degrees lean (I didn't want my print to go to waste). I made a version that is 10 degrees of lean for others to print.

The stand prints as 3 main pieces, the two legs, and middle section. They all clip together firmly. 

If you want to make the stand a different size, you can resize all the parts in your slicer, or just change the width of the middle section's model to make it narrower - just make sure if you do this that you don't change the sizes of the clips, as they fit perfectly as they are.

TIP: I print with “exclusive” settings on Cura to make sure the parts that clip together are dimensionally accurate

Happy printing !