SOVOL SV08 Silicone Nozzle Cleaner & Purge Bucket Minus Load Cell brass brush option

…Please be sure to hit like & post a make, I'd love to see your prints!

MACROS AVAILABLE HERE…!

https://github.com/3DPrintDemon/Demon_Klipper_Essentials_Unified/

EDIT: ADDED SILICONE MOUDLE for use with silicone pads, including the one from the stock load cell unit! Let me know if they need changing & I can modify them!

Replacement nozzle cleaner brush & purge bucket for loading & unloading.

While the stock load cell works I prefer to set my Z offset manually, also sadly the system is not accurate enough to be used as a definitive automated system, it always needs an little adjusting.

Also the silicone cleaner pad is ok but the brush seems to work better.

Plus when the printer is enclosed you will find a purge bucket infinitely more useful than a load cell!! Trust me on this!

x6 6x3mm magnets 

x2 M3 18-20mm bolts

x1 M3x5x4 (Voron BOM) heat insert & 6mm bolt

Brass cleaner brush from Ali or Amazon.

Print ASA, ABS. 

Choose low or high brush version.

Insert the magnets into the holes on each model so to they attract!! IMPORTANT!!!

Magnet holes are a tight fit! You will probably need needle nose pliers to squeeze them in. This is for a reason & to be expected.

Use heat insert & small bolt the block the brush from sliding out the holder once installed, remove for replacement of brush.

I will be publishing a macro set for this soon!