Bike beverage buddy - can and cup holder

Fathers days tours are difficult. You need to ride a bicycle and at the same time have a place to store your beverage, but your hands are busy. Suffer no more, because here is the solution - the bike beverage buddy. Hands on driving but have your beverage ready for any stop.

You can use it for:

• Beverages
• Espresso
• Elderflower-Lemonade
• Raspberry-Lemonade

The Clamp is designed with a diameter of 32mm. For smaller handle bars, you need to add some rubber or other padding.

The following materials are needed:

• 2x Screws M5x40 DIN 933 for mounting with tools or
• 2x Screws M5x50 DIN 933 when you want to use the 3D Printed screw-head to mount it by hand
• 1x Screw M5x16 DIN 933 for 32mm brackets or
• 1x Screw M5x20 DIN 933 for 26mm brackets
• 3x Self-Fastening Nut M5 DIN 985 
• 3x M5 Washer

Printing Instructions for PLA:

Holder and Clamps:

• Orientation: lay on the side surfaces to improve stability
• Layer-height: 0.2mm
• Infill: 15%
• Supports: no

Screw-Knobs: 

• Layer-height: 0.08mm
• Infill: 100%
• Supports: no
• Brim: outer

You can find the model on Makerworld too: https://makerworld.com/en/models/465062