I designed another RaspberryPi Case that fits in the Prusa Enclosure (or any other M3 driven screw/insert), because I was not happy with what I found. I designed this one to add the RaspberryPi easily without harming it.
In many cases I found, I have to choose violence to bring it in. Here I designed the holding pins upside down, so you can easily add the raspberry without any pressure.
Printed with PETG Prusament
0.20 mm layer height
Support for the SD-Card slot and the side openings on the bottom part are added to the gcode files.
1 M3 heat-set insert. I used from Ruthex M3x5.7 (any other will to, if not longer than 5.7mm and a diameter of 4mm)
1 M3 8mm screw for the original Prusa Enclosure (you can choose what suits best)
The author remixed this model.