Wacom Pro Pen 2 Holder

Patreon - https://patreon.com/CosmicNimbusPrinting 
Cults3D - https://cults3d.com/en/users/CosmicNimbus

Hi !

I needed a new nib stand for my Wacom Cintiq Pro 13. After a look around, I found Bad Voxel's design. After printing it I realized it was for an older pen and the tolerances where very tight so I would have had to change to a smaller nozzle to print it.

So some time and iterations later, I've made this version that works with the Pro Pen 2. I took inspiration from the new style holders, and flipped the screw design so it will print with no supports. I also tightened up the nib slots, added more slots for more nibs, and included the hole in the bottom that you can use to remove the nibs from the pen.

Printed at 0.12mm layer height, with a 0.4 nozzle on my Ender 3 V2 Neo.

Happy printing !

• Looser tolerances on the screw so you can print with a alightly larger nozzle
• Flipped screw design so it prints with no supports
• Added extra nib slots
• Tightened nib slots to fit the new smaller nibs
• Added Nib remover hole in the bottom piece
• Round style inspired by the newer pen holders