Meile CX1 handle retaining clip

Being the sucker I am, I spent too much money on a vacuum to only have it break within a couple of weeks of owning it. 

This model replaces it with something that requires much less parts and has been more reliable.

Print Parameters:

Printed in PLA at 0.2mm height with 3 perimeters. Enable supports on build plates only.

Post-Processing:

The clip part needs to be separated and will be a bit stiff. Push it out from the inside to pop it loose. I used some double sided velcro strips to tighten it on, but cable ties would also work. To release the clip from the handle pull it out by putting a nail or something under the small ridge and pull.

NOTE: REQUIRES BOSL2