A light protective case for a Bioenno 12ah battery. Specifically this fits model BLF-1212A.
I use the battery for ham radio remote activation's. I wanted something light weight that could provide some protection to the battery.
I printed mine out of Fusion Filaments HTPET+ Carbon Rod Black, but any material will work. Supports are not needed.
Some other settings I had were .02 layer height, 2 walls and 4 top and bottom layers. I used 15% gyroid infill.
A note on the lid file. I have 6 of these total in use. They are each made out of a different filament so I can identify the battery. Some of them snap on fit perfectly and some are a little loose. On the ones that are loose, I added a few drops of super glue at several points in the channel on the lid. The ones I printed out of ASA seem to fit the best but I'm sure your experience will vary.
The author marked this model as their own original creation.