Bee / Insect hotel

Oval shaped bee/ insect hotel with printed guard plate for protection againt predators like birds.

Model can be printed in 1 or 2 sessions. When printed in one session you'll need supports for the clips of the guard plate. When printed in two sessions just glue the parts together with hot glue or Gloop.

Guard plate has to be printed seperately.

Best material to print the model is with PETG or ASA. Print with 4 or 5 outer layers in case the model is hanging in a place where it may get wet.

Information about the model;

• Total length:    210mm
• Outer height:  200mm
• Outer width:    160mm 
• 3 screw holes, use the 2 on the sides or the 1 in the middle

Maximum length of the sticks that will fit inside the hotel is 120mm or you can print the honeycomb pattern which can be placed inside the hotel.