Handpan stand

You need:

• 3x 100cm Woodstock ⌀ 24mm
• 3x melt-in thread M4
• 6x wood screws for antislip-caps
• 4x M4 20mm screws 
• 200cm Paracord ca. ⌀ 4mm

What to do:

• Print 1 ring, 6 anti slip-caps & plugs and 2 rope-chinch
• Ring printed wit PETG (50% infill), Antislip caps printed with TPU
• Insert melt-in threads into ring from outside
• Shorten broomsticks to 100cm from both sides, so you get flat ends
• Mark 40cm from one side
• Drill a 4mm hole in every of the three broomsticks, but only ca. ⅔ of diameter - exactly at the right angle
• Screw antislip-caps with wood-screws on top and bottom of every broomstick and close holes with plugs
• Put all 3 broomsticks into the ring and screw M4 screws through the ring into the holes in the broomsticks - not to tight
• Place stand, mark with drilling-guide holes for paradors on top & bottom and drill through drilling-guide
• Use paracord and rope-chinch on top and bottom to stabilize in your height

Have a lot of fun playing standing upright with you hardpan! If you want to build a stand for playing sitting on a chair simple use shorter woodsticks.