Min : Mount for M4 Extruder

This is the piece you need to go in between a M4 extruder and Min's frame - no parts are modified from either project.

The M4 is designed to normally mount to a 2020 extrusion frame with M5x10 screws and T-nuts - this bracket just replaces the T-nuts with hex-nuts.  The bracket mounts to the frame in the stock position using a pair of M3x22 or M3x25 screws.  There is also a slot for a ziptie in the back to keep the motor wiring tidy.

After printing, use the M5 screws to suck the nuts fully into the pockets before doing anything else - they are tight by design, and get tighter the deeper the nut gets so hopefully don't fall out once in place.