Greetings, I'm really a fan of your projects.
Quick question:
Would it be possible to locate the exhaust vent at one of the sides rather than the back?
Thanks for your great effort!!!
Greetings, I'm really a fan of your projects.
Quick question:
Would it be possible to locate the exhaust vent at one of the sides rather than the back?
Thanks for your great effort!!!
Struggled allot printing parts with the correct measurements.
This was all due to my inexperience with printing large functional parts.
Printed with cheap ASA and had to deal with some shrinkage.
Thanks to Nadir and the help in his Discord i learned allot a new things!
we learn every day
glad i could help and thanks for sharing your experience and for rating the model.
Where is the filament sensor supposed to go?
@WayneManion_773439 we use a smaller version but you can use also the original filament sernsor in the hack where is the exhaust
Hey @Nadir
Great work, but I don't have space for filter in the back. Is it possible to place it on the side?
@dbarwikowski yes search we have a version with side exhaust ;)
@Nadir thanks!
For all the others, here is the model
https://www.printables.com/model/977944-sovol-sv08-top-hat-right-side-exhaust-filter-for-t/comments
Any way to get a ... perhaps double layer right front panel that has the cutouts to mount a BTT HDMI5 enclosure that has the tabs to mount on the bottom center? I'd prefer to mount it on the top tophat
@Nadir I did indeed see that. It requires screwing the hdmi to the top hat. Was thinking more like what sovol does for it's screen on the bottom. The two slots?
can I turn it to where the filter system is on the (right or left) side?
I had a question about the exhaust fan, am I disabling and blocking off the one on the factory enclosure kit because heat rises? Thanks, kit is printed in ABS and installed. Thanks for your contribution to this platform. (edited)
@JViccari_430961 we are working in a new solution to recirculate the air.
Can I use this to stack 2 sv08s on top of eachother?
@Nadir ah lol didnt think of that, thought id ask. I just got them and trying to figure out the most compact way of doing so with minimal amount of floor space
@ShaggySander_2126008 build or buy a table, put one printer under the table and one on top.
Any chance to add update for the coprint multi color setup?
What are the recommended infill and wall loops settings?
@Mrtaco789_348872
3 walls
5 top
5 botton
15% Infill Gyroid
being a big part please test and adjust if needed for shrinkage
Hallo wann kann man das wieder kaufen, und würde auch paypal gehen?
I will check this .... as I would like to make the enclosure pannels with wood , cutting with my diode laser .. (edited)
@cryo you have the dxf panels and you can cut them from 3mm ply https://www.printables.com/model/879399-sovol-sv08-panels-for-the-enclosure