Pogo Pin Holder for Clip

I needed a pogo pin clip and liked the ability to set the number of pins with https://www.printables.com/model/51522-pogo-pin-serial-adapter-customisable, but wanted to add it to a clip rather than hold it in place by hand.

The clip used can be found at https://github.com/puzrin/pogo_pins_clip; I printed it at 100% in PETG infill for strength, but not sure if that was necessary or not.

The pogo pin holder I also printed at 100% in PETG with supports with the added mount on the build plate.

I've included an 8 pin and a 5 pin version for printing (the two I most commonly need), but you can adjust the number of pins by editing the OpenSCAD file and adjusting the value of ‘ppc’.

This remix adds a back to the adapter allowing it to be attached to the clip found at https://github.com/puzrin/pogo_pins_clip.