Haldis 3D Red Lizard Q1 V6 Ender 3/CR-10/ Shroud and fan Duct

The default petsfang needed a lil modification to work with the red lizard q1 v6, i installed this on both my ender 3 and my cr-10 this was a great hot end! like all great hot ends make sure you properly install it/assemble or you will get leaks.

petsfang original - https://www.thingiverse.com/thing:2759439/

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

Yes

Resolution:

0.2

Infill:

80

Filament: any petg any

Notes:

follow the notes on the petsfang page for supports and speed.
basically limit speed to 40mm/s max travel at 100mm/s supports to 40 degrees 6 walls 80% infill