The ultimate VR Racket [quest 3/PRO]

Single-part model of a racket for Virtual Table Tennis Games. No screws, no bolts, no Velcro tape... Just fit the controller inside and play.

If you have controllers from Meta Quest Pro, you can charge them without removing them from the racket!

I printed it with ABS using 5 loops. Consider adding more in the area of the handle if you want to achieve weight distribution closer to that of a real racket.

WARNING!!!

Be careful when inserting and extracting the controller. Because it's a tight fit, you can scratch your controller, especially if the printed racket has defects on its surface. I recommend slightly opening the jaws of the racket with your hands and sliding the controller inside little by little.

P.S. I left a place for a latch mechanism but turned out it's not needed. 

P.S. Always you this racket with safety string over your finger.