K1C Lid Riser

Just a simple remix of the lid riser, I dont print PLA or PETG so I prefer a solid riser as I want to reduce heat leakage as much as possible, I also reduced the gap at the rear and put the K1C logo on the left.

Print with supports for best results, I used ABS-CF for mine and I recommend using ABS for better heat resistance.

Print the following:

• 1 x Short Section
• 3 x Long Section
• 1 x Right Rear Corner
• 2 x Right Front and Left Rear Corner
• 1 x Front Left Corner

Removed the ventialtion

Put logo on the left

Closed up the rear to reduce heat leakage