Multi-filament spool holder for Ender 3 V3 SE

This is my holder for multiple filament spools. I just got bored, so i made it to hold up to four spools of filament for my Ender 3 V3 SE.

----------------------------------------------------------------------------------------------------------------
For 2 spools (max width of coil: 10cm) use files: stojan v1, tyc v1, drzak
For 4 spools (max width of coil: 8cm) use files: stojan40cmf and m, tyc40cm1

----------------------------------------------------------------------------------------------------------------

For assembly you will need only glue to make parts stick to themself. Every part is made with deviations to match the other. All thing is mounted on top side of printer using original screws from original holder.

----------------------------------------------------------------------------------------------------------------

!!!DISCLAIMER!!!

I only printed smaller version that's working great, but longer version should be working. But if is anything wrong with longer version, please give me feedback so I can improove it. Also I made by mistake “drzak” longer than it should be (on photos) but this version is properly measured to be lower.