Unicorn joint holder (vase mode!)

This is one of my first designs. I wanted to create a joint holder that would be easy and quick to print, and use little material, so I chose a solid version to print in vase mode.

Size is 90 mm tall and 15 mm opening, then narrowing down to about 8 mm.

Printing tips:

• Both parts are properly oriented for printing (flat surfaces against the print bed)  
• Use vase mode
• Print each part separately
• Layer height: 0.25 mm
• Wall thickness: 0.7 mm
• Leave a few bottom layers (I used 4)  
• Temperature: Hotter than normal (I increased 10º C using normal PLA and silk PLA)
• Depending on your printer and surface, the body might need a brim for better adhesion