Prints fast and super nice - printed the "negative hook for better catch - guided" model in PETG, 0,15 layer - 0,4 nozzle.
Had to shorten the trigger on the bottom of the slider a bit, so more tension is build up before releasing the blade. The initial print had not enough force to fully slide the blade out.
Thanks for sharing that model - it's super fun :) (edited)
Very cool design. Springs and latches work great. Printed in Jessie PETG Glitter Black. Fun to play with!
The slider with normal spring (grey model) didn't work, and the slider with even stronger spring (blue model) worked quite well for the 1st two weeks, then no more :/ It was good fun until then
Worked okay in pla for a while but the slider broke so now it only goes down.
Printed nice
The strong spring prints well but is harder to use the switch and most of the time breaks the small pleases (the blade catcher and the blade releaser)
Printed well
Works well with the normal spring now breaking
Doesn’t retract all the ways and I have to press it down
Looks cool
Works pretty well
Fun to play with all peaces print in 1hr 40mins total
