RockNRoller Filament Guide

Dear Printer Dudes and for all selfmade enclosure builders,

i found so many good parts here and finally i hope to give you something back ;-)

Just designed and tested the all new RockNRoller Filament guide.

It can be used for any hole through top of an IKEA table but in special with the cone tunnel from here:

https://www.prusaprinters.org/prints/30576-ikea-lack-filament-guide

The files are optimized for bridging, pressfit tolerance and of course good print quality, since you need to press some beerings into the brackets.

Used Material: 

• PLA-Lemon green (Prusament of course)
• 2x RS608 Roler Bearing
• 2x Wood screw stainless 3,5x25
• 2x 4,2 washer

If you like it, I love it!

UPDATE: bottom bracket has been adopted not to slip any more after some time of use!

Cheers