Two-sleeved-decks-draw-and-discard

Each slot in the card holder will hold approximately 65 sleeved poker sized cards.

Main intent is to use with Firefly - The Game.

The holders will hook together at the ends.

I printed with .4mm bottom layer, and .2mm layers.

To snap the top to the bottom, you may need to clip a small amount out of the detent of the front posts on the bottom.

Created with Customizer! https://www.thingiverse.com/apps/customizer/run?thing_id=434793

Custom settings provide room for card sleeves, more angle, and make the posts sturdier - vs the original creator's default settings.

Instructions

Using the following options:

holder_count = 2
card_width = 64
card_length = 90
holder_height = 40
top_offset = 14
overhang = 16
angle = 12
card_gap = 5
bar_thickness = 2.5
support_gap = 0.25
clip_card_gap = 0.25
both_gap = 5