ToF enclosure VL53L0X - GAGGIUINO

Print in place ToF enclosure with a hinge and embedded magnet pockets.
7
26
0
338
updated April 29, 2024

Description

PDF

As I didn't found an enclosure that checked all the boxes, I've designed it myself. It's a an enclosure with a print in place hinge and embedded magnets. Has the space for the soldered wires that are going to stick through the back. The pocket where are going to pass the wires is big enough for all of them(if you need). There's a notch to keep the enclosure closed. The hinge has a 0.2 gap, and the magnet pockets are meant for four 5x2 mm magnets(if you are doing the Gaggiuino build, they are the same as the magnets used for the hardware scale). The magnet pockets are 5.2x2mm as usually they are a bit thinner I didn't make the hole deeper.

Components:

As for the print settings:

  • nozzle: 0,4
  • speed: 40mm/s
  • fan: 100%
  • brim: yes
  • support: no
  • material: as you like(I've used clear PETG)

To add the magnets, set trough the slicer: stop the print at a layer 11 

insert the magnets, and resume the print.

That's the end result 

 

Tags



Model origin

The author marked this model as their own original creation.

License