I was looking for a clothespin basket but didn't really find what I was looking for. So I opened up Vectorworks and quickly drew this up. It prints in two parts and just needs some glue to assemble.
I printed this out of regular PLA with marble look and it is holding up perfectly so far. Print the hook lying flat. I didn't put any clearance so you might have to scale it down a bit to fit perfectly. I printed mine at 98% and had a nice press fit. After printing is done, just put some superglue in the center hole, insert the hook and you are ready to go.
The author marked this model as their own original creation.
