Skadis hook for wire cutter (thicker and stronger clip)

I liked the original model for its minimal look, but the clip snapped off after printing it.
I remix it with a stronger clip after snapping the original.

I make sure to do the remix to be printed with no support.
It turned out alright 

Thanks to @NemetIstvan for making this in the first place. 

🍻🍻

UPDATE 11/06/2024

The model was a bit too loose for someone. Created a V2 which has a gap 1mm smaller. This new version fits perfectly my skadis without wobbling. 

A thicker and stronger clip, it prints with no support.