Analogue Duo Vertical Stand with HuCard Display Bracket

Important

I do not know enough about the Analogue Duo to claim that it can safely operate in this orientation. Please consider removing it from the stand before using it, otherwise you are responsible for any risk or damage to the unit.

Description

A vertical stand for showcasing your Analogue Duo without using up valuable shelf space. Included are two versions: power button at the bottom (in photos) or on the top. I made a few additional tweaks after the photos were taken including a wider base and taller sides. Refer to the render photos and live 3D view.

Also included is an extension bracket for a HuCard so that you can fully display the label while inserted into the Duo.

Print Notes

-  The base can be printed as is. >=10% infill of your choice and at least 2 walls should be fine.
- The HuCard bracket should be printed on its side as shown in the render. The walls are thin (0.5 mm) in order to fit into the Duo. If you're having trouble with bed adhesion, try using a brim to keep it attached