inserts for lube station addon

printed this lube station addon but due to my higher layer heights due to using a .6 nozzle i found the overhangs were drooping a significant amount and caused both an extremely ugly finish in the bottom of the tray and lube container holes aswell as some gaps around said drooping, instead of trying to reprint the part with a lower layer height and wasting filament i decided to just quickly slap together these small inserts to fit into the holes to give them a flat, solid base, the lube container hole inserts are a lot looser so might end up with a bit of a gap between it and the walls of the hole, but the tray insert should be a little tighter, didnt want to bother trying to fine tune it as i dont think it really matters. inserts can just sit loose int he hole if you wished but i super glued mine down but you could use any kind of adhesive you wished

both inserts are 0.84mm thick to leave me with 3 layers with my layer height of 0.28, but if you wished you could adjust in tinker cad to fit your wishes