Artillery X3 bolt up ribbon cable cover

I prefer a bolt up solution for Artillery ribbon cables. This is the excellent X3 cover (thing:6596529) from Bockobg Константин Димитров and thing:4881286. I basically cut the ribbon connector off both and merged the bolt on style using 3d builder. it's basic but works. A small bit of foam on the inside of the cover tab cushions the cable a little (and aligns it). 

You will need to print 1 cover, 2 small grills and 1 large grill.

Printing the cover can be tricky. My advise is to use supports and set it laying on the front face. Use atleast 6 walls and preferably 100% infill. Grills do not need supports.

I prefer a bolt up solution for Artillery ribbon cables. This is the excellent X3 cover (thing:6596529) from Bockobg Константин Димитров and thing:4881286. I basically cut the ribbon connector off both and merged the bolt on style using 3d builder. it's basic but works. A small bit of foam on the inside of the cover tab cushions the cable a little (and aligns it).