Healthy Rips (HR) Dosing Capsule Filler

Hey!

This is a Dosing Capsule Filler made for the Healthy Rips Rogue Capsules

The Dosing Capsule Filler fits 4 capsules inside. Take the top off, put the empty capsules in and then put the top on. This makes it easier to fill them all up quickly.

The top is made to be snug. For my printer, the .10 offset option fit perfectly with very minor sanding with 800 grit to get it to slide off perfectly. You may need to experiment depending on your printers calibration.

Future plans:

• Make a version for the smaller capsules (Fury Edge Capsules)
• Make a version for the S&B Mighty Capsules

Versions:

• V1 First upload (27-April-2024)

Print Instructions:

Bottom

• Print on its base. (Capsule slots facing up)
• No supports
• I printed at .2 but you can change to any quality you want.
• 4 Walls
• Infill 20% (again, do as you wish... Less may be fine)

Top

• You only need 1 Top. Select the one depending on your printers calibration. higher the number (offset) the looser it will fit. I was able to use the 010 offset just fine.
• I printed at .2 but you can change to any quality you want.
• 4 Walls
• Infill 20% (again, do as you wish... Less may be fine)

Post Processing: You might need to sand the edges of the top so that it comes out of the bottom without much force. It should be snug enough to hold itself but easy to take off so you don't spill anything. You can print a higher offset (ex: .0.20 version) to ensure it's easy to pull off.

Print Settings

Printer:

Ender 3 S1 Pro

Rafts: 

No

Supports:

No

Resolution: 

.2

Infill:

20%