Universal bracket - Screw replacement

After moving house, I wanted to hang my Fritzbox and various other devices on the wall or on cupboards again. Unfortunately, I would have had to drill and screw everything again and create new, unsightly holes in my cupboards.

So I designed this universal bracket, which fits into most holes for hanging electronics.

It is parameterized, so you just have to change the parameter “distance” to your desired size.

I then attached the holder to walls and cupboards using nanotape, as this leaves no residue.

You should print it as shown, as this creates the best strength for the fake screws. You will need a little support for this.

I hope this helps you too.

Don't forget to like.