DJI RC 2 Camera Strap Adapter

An adapter for the bottom screws of the DJI RC 2 to attach a 10-12mm camera or other thin strap to the remote to avoid it falling down. You can use 4mm screws (at least that's what they measure including the screw thread) and if they have a slanted head, they sink in perfectly, if not, I have a non-slanted model. 

For secure attachment best use the strap loop and buckle, if you don't have any lying around I recommend these prints (also shown in photos)

Strap loop: https://www.printables.com/model/55477-nikon-camera-strap-loop/files (no support neeeded, but add a border)

Strap buckle: https://www.printables.com/model/859344-camera-strap-fastener (minimal support from heatbed needed)

I printed using a 0.6mm nozzle (but smaller is maybe even better) and a 0.15mm layer height with PLA for everything, which turned out great. No support needed.

Fly, don't fall.