Playmobil Truck Axle Clips / Achshalter

This is a remix slightly adjusted to print easier by making the two originally very thin strengthening struts at the bottom much wider. Before this change, print would always detach on my glass-bed equipped Anet A8.

The part is a axle / wheel holder clip for older Playmobil truck models.

There's also an updated version that provides a significantly tighter fit by adjusting the clamp dimensions. The original version had a tendency to come off, but the tighter version holds very well, so recommend to use that one.

German: Bei diesem Ding handelt es sich um einen Radhalter bzw. Achshalter Clip für ältere Playmobil Laster bzw. LKW.

Print Settings

Printer Brand:

Prusa

Printer: 

Prusa Clone

Rafts:

No

Supports: 

No

Resolution:

0.2

Infill: 

10%

Filament: Doesn't matter PLA Grey

Notes:

Any material does the trick.

Category: Toys & Games

Made the two originally very thin strengthening struts at the bottom much wider. Before this change, print would always detach on my glass-bed equipped Anet A8.